14
Although aluminum is extremely exible this might damage or even
break the poles. Every VAUDE tent comes with a Pole Doctor or repair
sleeve. If a tent pole breaks while out on a trip, simply slide the repair
sleeve over the broken section and then use tape to attach it (Z).
• The tent should only be cleaned by hand, never in a washing machine! Use
a soft cloth and luke warm water. Detergents or cleaning agents may harm
the tent’s coating and waterproong.
Use a brush to rub Nikwax Tech Wash in a 1:4 ratio with water on stub-
born stains. Follow up with Nikwax Tent & Gear Solarproof waterproo-
ng, applying generously to the area cleaned.
• When on the road, repair tears in the tent wall with repair tape and seal
from the inside with a PU or silicon seam sealer. The seam should however
be correctly repaired as soon as possible in order to prevent further
tearing. Please contact your retailer to do this.
• Tent pole shock cords can be retightened if necessary (elasticity can wear
out in very cold conditions or due to aging). To do this rst remove the end
cap and then untie the knot in the cord. Retie the knot further up the cord
and replace the cap.
TECHNICAL DETAILS:
Depending on tent models, VAUDE tents feature the following:
FEATURES:
Siliconized:
• Increases tent life by 20% - a triple coating reects damaging UV radiation
to a much greater degree than standard treatments.
• 8-times greater tear resistance – siliconized fabrics attain a tear resistance
of 8-11 kg compared to 1.3 kg of PU coated fabrics.
• Excellent water beading properties – water simply beads on the surface.
• Retensioning – the nylon carrier material swells up when damp or wet.
The tent needs to be retensed if rain/snow initiate.
• Sealing – siliconized materials cannot be factory seam sealed (exception:
VAUDE Silicon Seam Seal). When camping in extremely rainy conditions
we recommend sealing all seams by hand with a silicon seam sealer.
GAL_TENT_Mark_3P.indd 14 08.08.2011 11:51:50
To Next Page
Loading...
