164 Vehicle care
2. Turn bulb holder anticlockwise
and remove from housing.
3. Pull bulb from bulb holder and
replace it.
4. Insert bulb holder and turn
clockwise.
5. On left side: insert front end into
front wing, slide forward and insert
rear end.
On right side: insert rear end into
front wing, slide rearward and
insert front end.
Number plate light
1. Insert screwdriver in bulb
housing, press to the side and
release spring.
2. Remove bulb housing
downwards, taking care not to pull
on the cable.
3. Lift flap and disconnect wiring
plug from bulb holder.
To Next Page
Loading...
