Getting started
Fixing the wall bracket
Fully assemble
the vacuum.
Use both screws and wall
plugs to secure the wall
bracket to the wall. Place
covers over the screws.
Slot the wall bracket through the groove
and lift upwards into position.
Firmly press the vacuum
handle into the wall
bracket to secure.
Choose a position where
you would like to keep the
vacuum stored, preferably
near a mains supply. With
the wall bracket attached,
stand the vacuum close
to the wall, in the upright
position with the Powered
Head at on the oor.
Using a pencil make
a small mark for
each screw.
Holding the wall bracket
rmly in place, carefully
lift and remove the
vacuum away from
the wall bracket.
To Next Page
Loading...
Need help?
General
