Getting started
Assembling your upright
Press both buttons at end
of hose and insert into
hose entry point.
Insert hose grip into
extension tube.
Insert the other end of the
telescopic tube into the
oorhead.
Before you begin cleaning
IMPORTANT: The vacuum cleaner is equipped with a thermal cut-out. If for any reason the vacuum cleaner does
overheat the thermostat will automatically turn the vacuum cleaner o. If this happens, switch the vacuum cleaner
o and unplug. Remove and empty the dirt container also check the vacuum cleaner for blockages. Allow the vacuum
cleaner to cool for approximately 1 hour (if you have cleaned the lters please wait 24 hours for the lters to fully dry
before putting back into the machine).
For best cleaning results clean the pre-motor lter every time the dirt container is emptied and replace
the post-motor lter every 12 months.
If the vacuum cleaner is blocked, switch o and unplug before removing the blockage.
PLEASE READ ‘LET’S TALK SAFETY’ AT THE BEGINNING BEFORE USE
CAUTION
Always switch o the vacuum
cleaner before connecting
or disconnecting the hose
/attachments, or removing and
emptying the dirt container.
To Next Page
Loading...
Need help?
General
