Remove dirty water tank. Open quick spout pour cap and partially ll dirty water
tank with clean water and swirl around to loosen debris.
To clean dirty water tank ducting, place dirty water tank
under a tap and dispense high pressure clean water into
the inlet port of the dirty water tank to loosen debris that
has accumulated.
Allow tank to dry
completely, replace quick
spout pour cap and insert
dirty water tank back
onto unit.
Storage
Empty and rinse out clean and dirty water tanks and leave to air dry
before replacing. Do not leave solution stored in the tanks between uses.
Taking care of your machine
TIP
During normal use of cleaning,
debris may accumulate inside the
dirty water tank. In order to keep
your unit functioning properly
and to prevent any odours
building up, it is best to rinse out
your dirty water tank with fresh
water after each use.
Cleaning the dirty water tank
IMPORTANT: Be sure to remove any debris that has accumulated in the screen above the oat. If the screen becomes
clogged, this may reduce the performance of your cleaner.
For full suction it is important that the quick pour cap is securely in place. If misplaced, suction will be severely aected.
Let’s talk technical
To Next Page
Loading...
Need help?
General
