PLEASE READ ‘LET’S TALK SAFETY’ AT THE BEGINNING BEFORE USE
Getting started
To secure the upper handle screw and tighten
with a cross/at head screwdriver.
Stand base in upright
position and lower the
top section until it clicks
securely connecting on
to the base.
Slide handle down
onto unit until it clicks
securely.
Assemble the two lower handle screws and tighten
with a cross/at head screwdriver.
Assembling your carpet washer
TIP
When cleaning an entire room,
move furniture out of the area
to be cleaned. If the furniture
is too heavy to move, place
aluminium foil or wax paper
under legs. This will prevent
wood nishes from staining
your carpet. Pin up furniture
skirts and curtains.
IMPORTANT: Carpets should be dry vacuumed thoroughly before washing.
Test for colourfastness – Wet a white absorbent cloth with the solution. In a small hidden area of your carpet/rugs/
upholstery gently rub with the dampened cloth. Wait ten minutes and check for colour removal or bleed with a white paper
towel or cloth. If your carpet has more than one colour, check all colours.
Test your carpet/rugs/upholstery – Run the carpet washer over a small hidden area. If no pile distortion occurs continue
cleaning.
When cleaning an entire room, move furniture out of the area to be cleaned. If the furniture cannot be moved, place
aluminium foil or wax paper under the legs. This will prevent wood nishes from staining your carpet. Pin up furniture skirts
and curtains.
When using the carpet washer, basic safety precautions should always be observed and don’t over saturate your carpets.
Only use Vax carpet solution. Using other solutions may cause excess foaming and will invalidate your guarantee. The clean
water tank should only be lled with warm water (max 40°C). Filling the clean water tank with hot/boiling water will damage
your machine and invalidate the guarantee. This is a powerful carpet washer, before plugging in make sure all controls are
turned o. Hold carpet washer rmly when staring and during use.