Emptying the water tank
Press the water tank
release button and pull
tank to remove.
Pull the tab on water tank
cap to open.
Empty any excess water
over the sink.
IMPORTANT: Don’t leave water in the tank between uses, this can eect the steamers performance, the water tank
should to be emptied and rinsed after each use.
Remove the pin from
the nozzle. Holding the
main body of the steamer
vertically, tap the nozzle on
a hard surface to release
any mineral deposits.
Clearing blockages
If there is an obstruction to
the steam ow through the
machine, steam may
be released through the
bleed valve.
Press the button on the
neck of the machine to
remove the oor head.
Using the de-scaling pin,
insert the full length of the
pin into the nozzle. It may
be necessary to twist the
pin to insert fully.
Taking care of your machine
To Next Page
Loading...
Need help?
General
