Using your machine
Cleaning the lter
Using your machine
After each use clean the water tank lter. Pull open the clean
water tank lid, gently remove lter
Rinse under water to remove
debris (max. 40°C) and leave
for at least 24 hours or until
fully dry before replacing in
the machine
Push switch to turn machine on, push switch
again to turn machine o
Step on handle release pedal to recline machine
The mode selector allows you to choose DRY mode
or WASH mode
To wet clean with spinscrub brushes turned on,
turn the dial to the WASH position
DRY mode raises the Spinscrub brushes o the oor
and also stops them spinning to allow the water to
be picked up
To move your machine from
room to room, with the
handle in the upright
position and tilt the machine
back on the rear wheels
Taking care of your machine
To Next Page