Using your machine Taking care of your machine
Using your machine and spinscrub brush
In WASH mode slowly move the machine forward to arms length
squeezing the trigger to release the detergent. Release trigger and
pull back the machine to pick up
The machine may be moved by
using the carry handle at the front
of the machine
Warning: Always remove the tanks before carrying out brush/nozzle maintenance.
Nozzle can be removed for easy
cleaning. Slide the two nozzle
release latches outwards
Remove nozzle by pulling
straight out and rinse under
running water to clean
Cleaning the nozzle and spinscrub brush
Pull spinscrub brush bar out. The brushes
can be rinsed under water to remove debris
(Max 40°C). To replace spinscrub brushes
press rmly and lock into place then click
nozzle latches back into place
The tanks should be emptied
and cleaned after each use
and before storage.
TIP
To Next Page