7
V
ax Careline 0870 606 1248
operation
Press on the handle release pedal and pull the cleaner back
into a reclined position (Fig.4/7).
While pressing the solution release trigger, pull the cleaner
in a backward motion. Release the trigger and push
forward in the same path to remove the dirty water and
solution from the carpet. Repeat if necessary (Fig.4/8).
When the dirty water reaches the max fill line on the dirty
water tank, empty the tank.
Hose Attachments
NOTE: DO NOT OVERSATURATE THE UPHOLSTERY
For best results use steady, moderate, forward and
backward motion.
Make sure upholstery is dry before use.
NOTE: If the hose attachment door is not replaced, there
will be no suction through the nozzle and the unit will not
operate properly.
Put cleaner in its upright position. Remove tools from
storage caddy. Assemble as shown. Connect the
upholstery attachment to the trigger adapter (Fig.4/9).
Remove the tank door. from the top of the dirty water
tank (Fig.4/10).
Insert the hose adapter into the top of the dirty water
tank (Fig.4/11).
Connect the hose water supply plug into the socket on the
lower left side of the cleaner (Fig.4/12).
Fig.4/7
Fig.4/8
Fig.4/9
Fig.4/10
Fig.4/11
Fig.4/12
To Next Page
Loading...
Need help?
General
