9
V
ax Careline 0870 606 1248
operation
To empty the water tank grasp the handle with one hand
and the nozzle with the other and empty into the
sink (Fig.4/19).
Cleaning the Dirty Water Tank
Rinse the dirty water tank and filter thoroughly with warm
water. You should allow them to dry fully before replacing
them on your cleaner to prevent mildew (Fig.4/20).
NOTE: Do not use any chemicals in the cleaning process.
Replacing the Dirty Water Tank
Lift the front of the carpet cleaner base off the carpet
with one hand (Fig.4/21).
Grasp the handle and hook the front of the dirty water
cleaner into the base, making sure that the front of the
dirty water tank is resting on the base.
The dirty water tank has three tabs on the underside
which MUST latch on to the underside of the base of the
cleaner. The base must be lifted so that the nozzle is flush
with the base of the cleaner (Fig.4/22).
NOTE: Failure to install the dirty water tank correctly will
result in poor dirty water pick up.
While making sure the dirty water tank is resting on the
base, place the rear of the tank into the base of the
cleaner, push down on the handle until it latches (Fig.4/23).
Empty and rinse clean the water tank after use.
Fig.4/19
Fig.4/20
Fig.4/22
Fig.4/23
Fig.4/18 Fig.4/21
To Next Page
Loading...
Need help?
General
