NOTE: Do not store cleaner with solution in clean
water tank or dirty water in dirty water tank.
Mineral deposits and mildew can form which will
affect the performance of the carpet washer.
7. Troubleshooting
WARNING: To reduce risk of personal injury,
unplug carpet washer before servicing.
Problem: The cleaner won't run
Cause: Not properly plugged into electrical outlet.
Solution: Plug in firmly.
Cause: No electricity in electrical outlet.
Solution: Check fuse or breaker.
Cause: On/off switch not turned on.
Solution: Push on/off switch to ‘on’.
Cause: Blown fuse/tripped breaker.
Solution: Reset circuit breaker or replace fuse.
Problem: Cleaner/accessories
won’t pick up
Cause: Accessories not attached correctly.
Solution: Refer to page 6 for fitting information.
Cause: The hose is clogged.
Solution: Remove the hose and tools. Remove the
obstruction.
8. UK Service & Help
Vax Care 0870 6061248
Monday-Friday
. 9.00am to 5.00pm.
An answerphone will be available out of these hours.
Any queries or concerns about using your Vax, call the
Vax Careline. Calls are charged at the UK national rate.
Please make a note of the serial number and model
number of your carpet cleaner befor
e calling. Ther
e ar
e
over 400 approved Vax Service Agents in the UK. For
the nearest Vax Service Agent, please call the Vax
Car
eline or visit
www
.vax.co.uk
9. Technical Specification
Voltage: 220 ~ 240V 50Hz
Wattage: 1300W
Clean water tank volume: 3 litres
Dirty water tank volume: 4.5 litres
Cord length: 7.5m
Weight: 7.7kg
Subject to technical change without notice.
Troubleshooting
6
Fig.6/3
V-020 User Guide.qxd 6/6/06 9:22 am Page 7
To Next Page
Loading...
Need help?
General
