Vax V-060 SERIES - Page 12

www.vax.co.uk
12
6. Remove the nozzle guard by removing the five (5)
screws. Look for any obstructions and remove brushbar if
necessary (Fig.8/6).
Clearing Blockages from the TurboTool
1. Turn the TurboTool/Power Brush over and slide off the
O-ring (Fig.8/7).
2. Pivot lowering housing and remove clog (Fig.8/8).
3. To re-assemble, be sure that the tabs are engaged. Pivot
the lower housing closed. Slip the O-ring into the groove at
the neck of the TurboTool/Power Brush to complete
reassumbly (Fig.8/9).
clearing blockages
Fig.8/6
‘O’ RING
Fig.8/7
Fig.8/8
T
ABS
Fig.8/9