Vax Service line: AU: 1300 361 505
NZ: 0800 800 900
7
Operation
Steam cleaning hard oors
Plug into mains, press on
button on the main body.
A blue light shows unit is
on and heating. Wait until
green light appears (within
1 minute).
To recline the unit place
foot on oor head and
tilt handle.
To produce steam squeeze
the trigger in short bursts.
To prevent overly wetting
oors, do not hold down
continuously.
Move the steam mop
slowly backwards and
forwards across the oor
paying particular attention
to high trac areas.
IMPORTANT: Please refer to oor manufacturer’s care recommendations before use and test the steam mop on
a discrete area of ooring to begin with.
WARNING: Never leave the stick steam mop in one spot on any surface for an extended period of time with a
damp or wet microbre cleaning pad attached as this may damage the oor surface. Your stick steam mop
should only be used on tiles, lino, sealed wood ooring including sealed laminate.
WARNING: Do not operate/use stick steam mop without water in clean water tank.
IMPORTANT: To reduce the risk of personal injury, unplug the steam mop when assembling the accessories.
IMPORTANT: When using on hard oors, always ensure the microbre cleaning pad is properly attached to the
oor head.
IMPORTANT: For 1 x 400ml water tank = 12 minutes steaming time (approx).