Vax VX24 - Replacing the Hard Water Filter

Taking care of your machine
Replacing the hard water lter
Pull to remove the hard
water lter
New lter
(beige/cream colour)
Hard water lter should
be replaced every 3 to 6
months or if discoloured
Remove the water tank
to access the hard
water lter
Taking care of your machine
3-6 Months
IMPORTANT: Don’t operate the steam mop without hard water lter in place. The condition of the lter aects the
performance of your machine, check and change lter periodically. If you live in an area of hard water the lter will
discolour or darken over time. Depending on water hardness and frequency of use, the lter should be changed every
3 to 6 months or if the lter has discoloured.
If there is an obstruction
to the steam ow through
the machine, steam may be
released through the bleed
valve located on the side of
the handheld
With the pad removed from
the oor head, insert a
small thin object such as
a paper-clip in to the steam
holes to remove a blockage
To remove the oor head
from main body push the
oor head release button
and lift
After oor head is removed,
using a thin object such as
a paper-clip (in the area
shown), insert to remove
the blockage
Removing blockages