Vax W87-DV-B - Page 7

Using your machine Using your machine
Washing hard oors (some models only)
CAUTION: To prevent damage to wood oors and other hard oors, follow the ooring manufacturer’s cleaning
recommendations. Inspect oor surface for worn nish, bare wood or separated joints. It’s not recommended to use the
carpet washer on oors if any of these conditions exist.
IMPORTANT: Before attaching the hard oor squeegee onto carpet washer remove tanks, or make sure tanks are empty
before lying the carpet washer on its back.
Using the SpinScrub and Upholstery wash tool
IMPORTANT: Check the cleaning code on your upholstery. Use the cleaner only on upholstery marked ‘W’ or ‘W/S’.
Check with the manufacturer before use. Run the SpinScrub brush and upholstery wash tools over a small hidden area to
test before cleaning. When using the hose, select Wash on the mode selector switch.
No water/detergent will be delivered on Rinse or Max Extract mode.
Choosing an accessory
TIP
Rinsing is not necessary,
but will help remove
detergent and residue
leaving your hard oors
looking fresher. Go to
‘Rinsing your carpets/
hard oor’.
Lie carpet washer on its
back, line up squeegee
with nozzle.
Unclip and remove hose.
Stand carpet washer
upright. Fill clean water tank
with water and detergent
tank with hard oor
detergent. Go to ‘Filling the
water/detergent tank’.
Line up detergent tube
connector with detergent
tube connection port. Push
and twist clockwise to lock
into place.
Select Wash on the mode
selector switch.
Click
Hook front of squeegee
onto edge of nozzle.
Lift cover on hose
connection port.
Plug into mains, press the
on/o button to switch on.
Squeeze trigger to release
detergent and water mix.
Squeeze trigger on
forward stroke, release
trigger on backward stroke
to extract detergent/water.
Push squeegee under nozzle
until it clicks into place.
Line up tabs on hose into
hose connection port.
Push and twist hose
clockwise to lock into place.
Press the recline pedal and
pull handle backwards.
Choose an accessory.
Press the on/o button to switch
on. Select Wash on mode
selector switch (No water/
detergent will be delivered on
Rinse or Max Extract mode).
Press trigger on hose to release
detergent/water.
Slide accessory tool over tab at end
of hose until it clicks into place.
Squeeze trigger on the
forward stroke, release trigger
on backward stroke to recover
detergent/water.