Taking care of your machine Taking care of your machine
WARNING: Always switch o and unplug the carpet washer from the mains before assembling, lling and emptying
the clean water tank, emptying the dirty water tank or before connecting/disconnecting the attachments.
WARNING: Always unplug the carpet washer before performing any maintenance/troubleshooting checks
All water and detergent must be removed from tanks.
IMPORTANT: If the hose or tools are blocked, switch o the carpet washer and remove the blockage(s) before
re-starting your machine.
Emptying the dirty water tank
Cleaning the base lint lter
Lift dirt water tank by
carry handle.
Empty dirty water over
the sink. Rinse dirty water
tank and lid under water to
remove debris.
Pull to remove dirty
water tank.
Clean the lter screen
located at the back of the
dirty water tank by scooping
out the debris.
Lift dirty water tank clip up
and outward to release.
Empty and rinse out clean and
dirty water tanks and leave to
air dry before replacing.
Do not leave detergent/
water stored in the tanks
between uses
.
IMPORTANT
Cleaning the nozzle
Lie carpet washer on its
back. The lter is located
behind the brushes.
Leave to dry for 24 hours
or until fully dry before
placing back in the carpet
washer.
Pull lter to remove. Rinse lter under water to
remove debris.
24
Remove dirty water tank.
Lift and pull top of nozzle
to remove.
Rinse nozzle under water
to remove debris.
Line up tabs on nozzle with
holes in carpet washer. Slide
tabs into holes, press down on
nozzle until clicks into place.
TIP
The lint lter should be
checked and cleaned after
every use, if blocked the
SpinScrub brushes may
not turn.
To Next Page
Loading...
