Taking care of your machine
Removing blockages from the SpinScrub brushes
Advance SpinScrub brush maintenance
Lie carpet washer
on its back.
Pull rmly to unclip each
side of SpinScrub cover
(one side at a time).
Leave to fully dry. Line up
tabs on side of SpinScrub
cover into carpet washer,
push rmly until clicks
into place.
Leave to fully dry. Line
up tabs on side of
SpinScrub cover with
carpet washer, push rmly
until clicks into place.
Firmly pull sides
of SpinScrub
cover to remove.
Remove individual
brushes, clean and rinse
under running water to
remove debris.
Remove any threads or
hair caught around the
brush, rinse under water to
remove debris.
Ret the individual
brushes. Line up tabs on
SpinScrub cover with
tabs on brush frame.
Push and clip covers until
click into place.
What to do if it goes wrong
• Check the ‘This pack contains’ panel on the box to make sure the part
is denitely included in your unit.
• It may not be plugged into the mains correctly: ensure that the plug is pushed
in securely and switched on.
• The power button hasn’t been fully depressed.
• If the carpet washer cuts out during use, disconnect from the mains, allow
to cool for one hour, empty the dirty water tank, clean the lter and check
hose and SpinScrub brushes for blockages.
• Make sure the clean water tank is tted correctly.
• The detergent/clean water tank may be empty.
• Check the carpet washer is on the correct setting no water will be
dispensed when using the Max Extract mode.
• No water will be dispensed on Rinse or Max Extract mode when
using the hose.
• The brushes will only rotate when the carpet washer is reclined
and turned on.
• The brushes will not rotate when set in the Max Extract mode.
• Check the lint lter and clean if necessary.
• The oat in the dirty water tank may have been activated. Empty the dirty
water tank if full. If the dirty water tank is not full then switch the carpet
washer o and wait for the oat to settle before re-starting your machine.
• The dirty water tank may be full and the auto shut o engaged. Empty
the dirty water tank.
• Make sure the dirty water tank is tted correctly and the tank cap
is securely tted.
• Check the hose for blockages.
• Check the SpinScrub brushes for blockages.
• Check the nozzle is tted correctly and for any blockages.
SolutionProblem
Is there an accessory
missing?
Why won’t the carpet
washer turn on?
Why won’t the cleaner
pick up detergent/
water/spills?
Why won’t the
detergent/clean
water dispense?
Why won’t the
brushes rotate?
To Next Page
Loading...
