Replace Clean Water Tank (A) inside Dirty Water Tank (B)
taking care to ensure that the space to allow the dirty
water back into the tank is lined up with the Solution Port
(C) (Fig.4/4).
Replace Motor Container (A) ensuring that the Solution
Pump Hose (B) is aligned with the hole in the Clean Water
Tank (C) so that it goes inside when the Motor Container
is clipped back into position (Fig.4/5).
WARNING: Machine must not be plugged in
during this stage.
Push the pre-treatment wand connector (A) into the
solution port (A1) (Fig.4/6).
Once the pre-treatment has been connected, press the
water pump button to on.
Using the wand and the trigger, apply the water and
solution to the carpet (Fig.4/7) Turning the spray nozzle
clockwise or anti-clockwise will alter the spray pattern
Releasing the trigger will stop the solution flow. The
treated areas should be left for 10-15 minutes (Fig.4/8).
NOTE: Do not over wet carpets
5
V
ax Careline 0870 606 1248
pre-treating the carpet
A
C
Fig.4/4
B
Fig.4/5
A
B
C
Fig.4/6
A
A1
To Next Page
Loading...
