Vaxcel T0694 - Troubleshooting

Page 5 / 5
221021
Assembly Kit
6607MM (1 SET) FOR T0694
6608MM (1 SET) FOR T0695
The following parts are available for re-order if damaged or missing.
Decorative cover Fixture Mounting ScrewMounting Strap
Troubleshooting
---The light does not work:
1. Make sure the wall switch and circuit breaker are on.
2. Make sure the wiring is correct.
3. Cover the sensor with dark color cloth to verify that the ambient light level is not too high.
---The light comes on for no apparent reason:
1. Re-aim the motion sensor.
2. Decrease the sensitivity setting.
3. Do not use a dimmer or timer to control the light fixture. Replace the dimmer or timer with a standard on/off wall
switch.
---The light flashes on and off:
1. Reposition the bulb away from the motion sensor.
2. Reposition the motion sensor.
3. The motion sensor is in “TEST” mode and warm up.
Gasket
Mounting Screw X2
#8/32X1/2 in
Mounting Screw X2
#6/32 X1/2 in
Mounting Screw X2
#10/24 X1/4 in
A: 8-3/4"
B: 11-3/4"
C: 8-3/4"
Wire Connector
A
B
C