9
ELCARE NORDIC: service.vaya@elcare.com
GEAR SHIFTER
1
2
1. Decrease gear
2. Increase gear
Pedal Assist Mode
Step on one of the two pedals in any gear of the booster. The motor will start under the
action of the inductor to provide you with the power output. Once you stop pedalling, the
pedal assistance will stop automatically.
USING THE E-BIKE
Before using the E-Bike, there are several dangers you should be aware of. Please read
the following section carefully if you are a beginner or riding the E-Bike for the rst time.
PLEASE READ THE FOLLOWING INSTRUCTIONS CAREFULLY
Step 1: Getting started – Take your E-Bike out of the box.
Step 2: Charge the battery – Make sure the battery is fully charged before you use the
E-Bike for the rst time. For charging instructions, please follow the battery
information and charging specications.
Step 3: Wear a safety helmet and protective gear to avoid possible injury.
Setup
Unfold the E-Bike. See the “Unfolding the E-Bike” section.
Seat Height
When seated, adjust the height so your foot can rest on the lowest pedal position. In the
optimal cycling position, there should be space to bend your knee slightly.
After tightening the fastener screw, put downward pressure on the seat to check if it is
tight enough and attempt to twist the saddle from side to side to ensure it will not move
when riding.
WARNING: Be careful not to move the seat bar over the minimum settings. See seat bar
markings. |||||||||||||
Seat Adjustment
You can release the bolt under the seat to adjust the seat angle or horizontal position.
To Next Page
Loading...
