■
IR receiver (omitted if adapter cable CA 1220 is used)
☞
Connect the 3.5 mm IR receiver jack to the REMOTE INPUT socket of the tuner.
■
TV antennas (accessories)
☞
Up to 4 TV antennas (e.g. VDO Dayton TVA 5100) can be connected via the ANTENNA
INPUT 1-4 antenna sockets of the tuner.
✎
For assembly details please see installation instructions for antenna (supplied with the
antenna).
Connecting accessories
■
AV sources
Two additional AV sources can be connected to the TV tuner.
☞
Connect corresponding Cinch cables to the AV inputs (“A/V Input 1” and ”A/V Input 2”)
of the tuner.
■
Second monitor
A second monitor can be connected to the “A/V OUTPUT - Video2” socket of the TV tuner.
The second monitor then always displays the same image as the first monitor.
Other possible connections
■ Connection to the car radio for audio signal output
The audio outputs of the TV tuner’s AV output can be connected to a free input on the car
radio (e.g. AUX) in order to output the TV 5200 audio signal over the vehicle’s loudspeakers.
■ WT 5100 (infrared audio transmitter) and WH 5100 (IR headphones)
The stereo output signal from the TV tuner can be transmitted via the infrared audio
transmitter WT 5100 and received wirelessly via the infrared headphones WH 5100.
The audio output of the TV tuner is connected to the WT 5100 input for this purpose. The
WT 5100 must be positioned at a suitable point in the vehicle.
Installation instructions
8
To Next Page
Loading...