www.vectorfog.com
06
CLEANING
INSTRUCTIONS
WHEN USING WATER BASED LIQUIDS
When fogging is complete, pour any liquid left in the tank to a suitable container
using a funnel.
STEP A
Operate the fogger for 1 minute with the nozzle opened to the largest droplet size
setting. This will get rid of any existing liquid remaining in the fogger's internal
tubes.
STEP B
Fill the fogger with some clean water and operate again for one minute.
Remove any excess water from the tank.
STEP C
WHEN USING EMULSIONS
After fogging, begin with STEP A as listed above. Once done, fill the tank with
appropriate solvent for the chemical that was used. Repeat STEP B, flushing any
chemical residuals left inside. Then repeat STEP C. Before storing, allow the tank to dry.
PLEASE CLEAN THE FOGGER AFTER EACH USE!
WARNING
To Next Page
Loading...