EasyManua.ls Logo

Vector VEC221 - Troubleshooting Common Issues; Unit Not Functioning or Fan Issues; Cooling;Heating Performance Problems; Slow Temperature Attainment Solutions

Vector VEC221
12 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
7
TROUBLESHOOTING:
ProblemPossible Cause/Remedy
Travel Cooler/Warmer is not functioning as cooler or warmer (fan is not turning)
Accessory outlet of DC power supply is not functioning -check by plugging in a
12Volt DC appliance. If not, clean accessory outlet and re-connect the Travel
Cooler/Warmer.
• Fuse or circuit breaker in accessory outlet is open. Reset breaker or check fuse,
and replace fuse if necessary.
• Ignition is switched off - start engine or switch ignition to “accessory” position.
Fuse in unit’s power cord is blown - see Fuse Replacement section for location
of fuse and instructions for checking and replacing fuse.
- Cooler/warmer is not cooling or heating properly (fan is not turning).
Fan is defective. Call Vector Customer Service department for return/replace-
ment instructions. This unit is not user-serviceable, it must be returned to
Vector Manufacturing for professional service or repair. Any attempt to
service by user will void warranty.
- Cooler/warmer is not cooling or heating, but fan is turning
Cooling unit is defective. Call Vector Customer Service department for
return/replacement instructions. This unit is not user-serviceable, it must be
returned to Vector Manufacturing for professional service or repair. Any
attempt to service by user will void warranty.
- Travel Cooler/Warmer takes longer than 2 hours to reach desired temperature inside
• Low battery or supply voltage.
• Unit will attain desired temperature more efficiently if items are pre-heated or
pre-chilled.
• Fan area is blocked - Move unit or object
SPECIFICATIONS:
Capacity . . . . . . . . . . . . . 5 Liter / 1.32 Gallons (US)/ 9 can
Power Supply: . . . . . . . . . 12 Volt DC
Power Cord: . . . . . . . . . . 7’, with 12 Volt DC power plug and 10 Amp fuse
Amperage draw: . . . . . . . 3 Amperes (approx. 36-watts)
Cooling Performance: . . . . Cools to average 40ºF below surrounding air
Warming Performance: . . Warms to 120°F above surrounding air.
High Temperature Limit: . . Automatic ON/OFF.
Cold/Heat Transfer: . . . . . Temperature-efficient, aluminum-coated liner
Insulation: . . . . . . . . . . . . CFC-free polyurethane liner
Heat Dissipation: . . . . . . . Built-in fan with long-life, brushless motor
Warm/Cool System: . . . . Non-wearing thermoelectric
Dimensions . . . . . . . . . . .7”W x 12”D x 10.5”H
Weight . . . . . . . . . . . . . .4.85 Lbs

Related product manuals