-
Important Note: When installing the two-pin jumper headers, the shorter pins
are inserted into the
c board.
10. Locate the two 100-pF ceramic trimmer capacitors. When inserting,
ensure that the three component leads are fully seated and that the
capacitor body is level. Install and solder at the following locations:
-
12. C12 100-
F trimmer
13. Locate the 510-pF polystyrene capacitor. This part may be
marke 511
or with 510 usin
the old markin
code s
stem.
14. Install and solder the 510-pF (510 or 511) polystyrene capacitor al
.
To Next Page
Loading...