Veeder-Root SERIES 7886 - Page 13

Installation, Operation and Service Manual
Series 7886 High-Capacity & 7887 Meter Registers |?
c. Seat the shaft, install washers and retaining ring to
secure shaft to left-hand side plate.
d. See that all fingers are free to engage wheels.
3. Stop Shaft Installation.
a. Install retaining rings on ends of shaft.
b. Insert stop shaft into proper hole in left-hand side
plate. See Figure 8.
4. Reset Finger Shaft Group Installation.
a. Rotate no-back pawl so that spring puts pawl under
tension. Slip an elastic band over the reset fingers and
pawl to hold pawl in position. See Figure 20.
b. Install shaft into left-hand side plate and secure with
retaining ring and washers. See Figure 8.
c. Engage pin on reset lever group with slot in reset arm.
See Figure 22.
5. Clutch Shaft Group Installation.
a. Install shaft in proper hole in left-hand side plate. Add
washers and secure with retaining ring. See Figure 8.
b.
Make sure that bevel gears that drive the totalizer are
free to turn.
Figure 17. Locking Disc, Eccentric and Washer Removal and
Installation.
Figure 15. Reset Cam Removal.
Figure 18. Unit Wheel Installation.
Retaining Rin
and Washers
Anti-Topping
Finger Group
Figure 16. Unit Wheel Removal. Figure 19. Anti-Topping Finger Group Installation.
11