Why is my Veeder-Root Measuring Instruments showing NO_CNST and the device state is OUT?
The status of a Veeder-Root Measuring Instruments device will be OUT if the constant data has not been received, resulting in a NO_CNST status.
Why is my Veeder-Root TLS-350R PLUS Measuring Instruments showing NO_DATA and the device state is OUT?
The status of a Veeder-Root Measuring Instruments device will be OUT if it has not received fuel/water/temperature data, resulting in a NO_DATA status.
General| Model | TLS-350R PLUS |
|---|---|
| Category | Measuring Instruments |
| Manufacturer | Veeder-Root |
| Number of Tanks Supported | Up to 16 |
| Line Leak Detection | Yes |
| Display Type | LCD |
| Humidity Range | 0% to 95% non-condensing |
| Compliance | UL, cUL, ATEX |
| Type | Automatic Tank Gauge |
| Sensor Compatibility | Veeder-Root sensors |
| Communication Interface | RS-232 |
| Power Supply | 120/240 VAC, 50/60 Hz |
| Dimensions | 10.5 in H |
To Next Page
