Page
8
Warnings And Alarms
The TLS Console is constantly monitoring its probes and sensors for warning and
alarm conditions, such as fuel leaks, excessively high or low fuel levels, and
equipment problems.
If there is no warning or alarm condition active the system displays the “ALL
FUNCTIONS NORMAL” message.
If a warning or alarm condition occurs the system displays condition type and its
location, either tank, input or sensor number.
The system prints an alarm report showing the warning or alarm type, its location
and the date and time the warning or alarm condition occurred.
If more than one condition exists the console will flash the messages alternately.
WARNINGS
These indicate that an in-tank alarm is imminent or that a system fault has occurred.
ALARMS
Alarms indicate a potentially dangerous situation may have occurred.
Do not ignore alarms!!!
Be sure you are familiar with the alarm response procedures for the site.
To Switch Off All Warnings and Alarms
Press the red ALARM/TEST key to silence the alarm.
The front panel warning and alarm lights cannot be turned off until the cause of the
condition has been rectified.
Similarly the warning and alarm displays remain until the cause of the condition has
been rectified.
PLLD/WPLLD Alarm Information
For PLLD/WPLLD line leak detection alarms, refer to following manuals:
• PLLD/WPLLD Alarm Quick Help manual (P/N 577013-727)
• TLS-350/TLS-350R Operator’s Manual (P/N 576013-610)
To Next Page
Loading...
Need help?
General
