1
Introduction
The MAG-XL RF wireless probe is designed for inventory-only monitoring of extra large in-ground and above-
ground tanks in applications where in-ground probe wiring is either impractical or non-existent. Procedures
contained within this manual include:
• Installing the MAG-XL Flex Probe in the top of the tank.
• Mounting the TLS XL-Transmitter and battery pack to the tank riser
• Connecting the MAG-XL Flex Probe cable and battery pack cable to the transmitter.
Other required devices, such as the TLS RF Wireless 2 (W2) System and the TLS console are to be installed
following instructions shipped with those devices.
IMPORTANT!
It is imperative that you read and follow the handling warnings and installation instructions discussed
in this manual to avoid damaging the MAG-XL Flex Probe and voiding the warranty.
System Requirements
The Veeder-Root Wireless 2 (W2) System replacement/spare parts are listed below:
• 330020-668 TLS RF Console for Wireless 2 & MAG-XL Flex Probes
• 330020-673 MAG-XL Transmitter for MAG-XL Flex Probes
• 330020-674 Transmitter for Wireless 2 devices
• 330020-669 Receiver for Wireless 2 & MAG-XL Flex Probes
• 330020-670 Repeater for Wireless 2 & MAG-XL Flex Probes
Contractor Certification Requirements
Veeder-Root requires the following minimum training certifications for contractors who will install and setup the
equipment discussed in this manual:
Installer (Level 1) Certification: Contractors holding valid Installer Certification are approved to perform wiring
and conduit routing; equipment mounting; probe, sensor and carbon canister vapor polisher installation; wireless
equipment installation; tank and line preparation; and line leak detector installation.
ATG Technician (Level 2/3 or 4) Certification: Contractors holding valid ATG Technician Certifications are
approved to perform installation checkout, startup, programming and operations training, system tests,
troubleshooting and servicing for all Veeder-Root Series Tank Monitoring Systems, including Line Leak Detection.
In addition, Contractors with the following sub-certification designations are approved to perform installation
checkout, startup, programming, system tests, troubleshooting, service techniques and operations training on the
designated system.
• Wireless 2
• Tall Tank
Warranty Registrations may only be submitted by selected Distributors.
To Next Page
Loading...
