Veeder-Root TLS-350R PLUS - Page 5

Table of Contents
v
MAG-XL Flex Probe Troubleshooting
Troubleshooting ..............................................................................................................31
Probe Out or No Probe Detected ...........................................................................31
Incorrect Product Height Reading ..........................................................................31
Figures
Figure 1. Site drawing - example TLS RF wireless 2 system site layout –
two Mag-XL Probes ................................................................................9
Figure 2. MAG-XL Flex Probe parameters ..........................................................10
Figure 3. MAG-XL Flex Probe installation with riser pipe, top mounted
in tank man way ....................................................................................12
Figure 4. MAG-XL Flex Probe installation without riser pipe, top mounted
in existing tank opening ........................................................................13
Figure 5. Wireless component dimensions ..........................................................14
Figure 6. Attaching conduit hangers to battery mounting bracket ........................16
Figure 7. Do not bend top 2 feet of probe ............................................................17
Figure 8. Do not twist one coil 90° from the others ..............................................17
Figure 9. MAG-XL Flex Probe components - man way install .............................18
Figure 10. MAG-XL Flex Probe components - pipe fitting install ...........................18
Figure 11. Correctly lowering probe into tank ........................................................19
Figure 12. Incorrectly lowering probe into tank ......................................................19
Figure 13. Installing TLS XL-Transmitter - man way riser pipe .............................22
Figure 14. Installing TLS XL-Transmitter - tank 2-inch pipe fitting .........................23
Figure 15. Connecting input wiring to transmitter terminal blocks .........................24
Figure 16. Connecting probe and battery pack cables to the
TLS XL-Transmitter ..............................................................................24
Figure 17. In-tank setup for TLS Consoles used with MAG-XL Flex Probes .........27
Figure 18. Alarm Limit Settings ..............................................................................29
Figure 19. Volume calibration examples ................................................................30
Tables
Table 1. MAG-XL Flex Probe Specifications .........................................................11