veito AERO - Installation Precautions

This heater is hot when in use. To avoid burns, do not let bare skin touch hot
surfaces. Keep combustible materials, such as furniture, pillows, bedding,
papers, clothes and curtains at least 150cm from the front of the heater and
keep them away from the sides and rear of the heater.
Always disconnect the heater from the electricity supply and allow adequate
time (minimum of 30 mins.) for it to cool before adjusting the position or
attempting to work on it.
Do not insert or allow ngers or foreign objects to enter any ventilation or
exhaust opening of the heater as it may cause re, electric shock, or damage to
the heater.
Never touch the heater with wet hands at any time. Do not touch any part of the
heater during operation.
Do not paint any surface of the heater.
Do not cover the heater.
INSTALLATION PRECAUTIONS
Installation must be carried out by a qualied and licenced person only.
After unpacking, make sure the appliance shows no signs of visible damage or
tampering. If the appliance appears damaged, contact the place of purchase for
assistance.
This heater must only be used on a 220-240V AC single phase electricity
supply.
Remove packaging and any transit protection before installation.
The installer is to ensure that the requirements of the local authority, local
electrical installation code, municipal building codes, and any other relevant
statutory regulations are carried out.
When using electrical appliances, basic safety precautions should always
be followed to reduce the risk of re, electric shock, and injury to persons,
including the following:
Do not run the power cord under carpeting. Do not cover with throw rugs,
runners, etc. Arrange the cord away from all trafc areas and where people will
not trip over it.
Keep the cable away from sharp edges during handling and installation.
Heaters have hot and arcing or sparking parts inside. Do not install this product
in areas where gasoline, paint, or ammable liquids are used or stored.
Do not allow the supply cord to sit or hang in front of the heater while in
use and keep it away from the body of the heater which will get hot during
operation.
3
EN