veito AERO - Maintenance Precautions

Do not use or install the heater in bathrooms, laundry areas, or similar indoor
locations. Never place the heater near a bathtub or other water container. Do
not place switches or controls within reach of a person in a bathtub, shower, or
swimming pool.
Do not locate the heater immediately above or below a xed socket outlet or
connection box. This is because the heat radiated from the appliance may
damage the electricity outlet or plug.
This heater must be grounded. Connect to properly grounded outlets only.
Ensure both plug and socket is clean and free from dust when using.
To disconnect the heater from the power supply, grip the plug and pull from the
power socket. Never pull by the cord.
Do not touch the plug with wet or moist hands.
Do not use an extension cord with this heater.
Install the heater using the stainless steel brackets provided. Do not use other
brackets for this purpose.
Do not remove this Installation & Service Manual or the provided spanners
from the site of installation. Ensure that the manual is stored safely for future
reference.
MAINTENANCE PRECAUTIONS
Repair or service must be carried out by a qualied and licenced person only.
If the appliance has not been used, or will not be used for a long period of time,
disconnect the power supply.
Ensure that the heater is serviced and inspected by a qualied electrician on an
annual basis.
Do not attempt to clean or service the heater until it has been switched off, the
power has been disconnected, and the heater has cooled to room temperature.
Regularly check the heater for damage. Do not use the heater if the heating
element is cracked or broken. If damage to the appliance is suspected,
discontinue use immediately and contact the supplier or qualied person to
repair.
Regularly inspect the power cord and plug for wear or damage and do not
operate the heater with a damaged cord, plug or loose socket or after the heater
malfunctions, has been dropped or damaged in any manner.
If the supply cord is damaged, it must be replaced by the manufacturer, it’s
service agent or similarly qualied persons in order to avoid a hazard.
4
EN