What to do if manual height adjustment does not work on Vela Samba Indoor Furnishing?
If the manual height adjustment on your Vela Indoor Furnishing isn't working, it might be due to excessive or uneven weight distribution. Attempt to adjust the height while not seated. If the problem persists, the gas cartridge may be faulty and require replacement.
Why does my Vela Indoor Furnishing chair roll badly?
If your Vela Indoor Furnishing chair isn't rolling smoothly, it's likely that the wheels are obstructed. Inspect the wheels and remove any accumulated debris, such as wire residue.
General| Brand | Vela |
|---|---|
| Model | Samba Series |
| Category | Indoor Furnishing |
| Language | English |
Essential safety guidelines for chair use, purpose, and maintenance.
Warning about small parts being a choking hazard for children.
Troubleshooting steps for when manual seat height adjustment fails.
Solutions for issues related to the chair's rolling or wheel performance.
Explanation of warning symbols and icons used on the chair for safety.
Details on the part identification label, including model and CE marking.
Specifies intended indoor use and maximum user weight capacity for the chair.
Details environmental conditions for transporting the chair safely.
Instructions for cleaning and checking the chair's wheels for optimal performance.
Guidance on cleaning the chair's frame using mild soap and water.
Specific cleaning methods for fabric, synthetic fabric, and leather padding.
Procedure for attaching the backrest, ensuring proper lever and pin function.
How to adjust seat height using the ring mechanism.
How to adjust seat height using the foot ring.
How to adjust seat height using the lever.
Adjusting seat height using the left-hand lever on Samba 400 and 530 models.
Adjusting seat tilt using the middle lever on Samba 520 model.
Adjusting seat tilt using the right-hand lever on Samba 400 and 530 models.
Adjusting backrest height using the lever on the chair's back.
Adjusting backrest tilt using the rear lever on Samba 520 model.
Adjusting seat height using the lever on Samba 410 model.
Adjusting the height of the armrests by loosening the handwheel.
Adjusting the width of the armrests by loosening the handwheel.
Adjusting the height of the 45 cm footrest ring for stability and support.
Adjusting ergonomic arm support for desired width and height.
To Next Page
