Velleman 3DPEN User Manual

3DPEN
V. 01 – 07/08/2014 4 ©Velleman nv
DO NOT disassemble or open the cover. There are no user-
serviceable parts inside the device. Refer to an authorized
dealer for service and/or spare parts.
Caution: Device heats up during use. Place the device on a
flat, heat-resistant surface. Do not place the device on
carpets, fabrics…
Do not use the device when damage to housing or cables is
noticed. Do not attempt to service the device yourself but
contact an authorised dealer.
3. General Guidelines
Refer to the Velleman
®
Service and Quality Warranty on the last
pages of this manual.
Protect this device from shocks and abuse. Avoid brute
force when operating the device.
 Familiarise yourself with the functions of the device before actually
using it.
 All modifications of the device are forbidden for safety reasons.
Damage caused by user modifications to the device is not covered
by the warranty.
 Only use the device for its intended purpose. Using the device in
an unauthorised way will void the warranty.
 Damage caused by disregard of certain guidelines in this manual
is not covered by the warranty and the dealer will not accept
responsibility for any ensuing defects or problems.
 Do not switch the device on immediately after it has been exposed
to changes in temperature. Protect the device against damage by
leaving it switched off until it has reached room temperature.
 Keep this manual for future reference.
4. Features
 heat extrusion
 filament: 1.75 mm ABS (included)
 adjustable printing speed
 for product designers, hobbyists and students

Velleman 3DPEN Specifications

General

Brand	Velleman
Model	3DPEN
Category	Accessories
Language	English