DVM9915
V. 03 – 29/11/2017 16 ©Velleman nv
19. Troubleshooting
If the device beeps continuously while measuring continuity, this means that
the F0.5 A/600 V internal fuse is defective.
Keep in mind that a low battery level could lead to incorrect measurements.
Replace the battery on a regular basis.
(tip: the reduced luminosity of the backlight/LCD display indicates a low
battery level)
Use this device with original accessories only. Velleman nv cannot
be held responsible in the event of damage or injury resulting from
(incorrect) use of this device. For more info concerning this product
and the latest version of this manual, please visit our website
www.velleman.eu. The information in this manual is subject to
change without prior notice.
© COPYRIGHT NOTICE
The copyright to this manual is owned by Velleman nv. All
worldwide rights reserved. No part of this manual may be copied,
reproduced, translated or reduced to any electronic medium or otherwise
without the prior written consent of the copyright holder.
Velleman nv
Legen Heirweg 33, 9890 Gavere, Belgium
www.velleman.eu
To Next Page
Loading...
Need help?
General
