Vello shutterboss II User Manual

7
Turning ON the Transmitter: The
Wireless ShutterBoss II is optimized for ultra-
low power usage. Pressing any key will wake
the device. If no operation is performed,
the transmitter will revert to standby status
in one minute, and the display will turn o.
The device will stay active during timing
operations and bulb exposures longer than
one minute.
Turning ON the Receiver: Press and
hold the power button for two seconds. The
display will show the channel in use. The
receiver turns o the same way. Press and
hold the power button until the display goes
o.
Press and hold the power button for two
seconds to power up the receiver. The LED
will blink green while the device is on.
The transmitter uses ultra low power, and
can last up to four years on standby.
POWERING UP

Vello shutterboss II Specifications

General

Supported Cameras	(See enclosed insert)
Exposure Range	0s to 99hr 59min 59s in one-second increments
Number of Shots	1-999 or ∞
Frequency	99 selectable channels over FSK 2.4 GHz
Range	250 feet (80 meters)
Timer Control: Delay	0s to 99hr 59min 59s in one-second increments
Interval	1s to 99hr 59min 59s in one-second increments
Operating Temperature	−4° to +122°F (−20° to +50°C)

Weight and Dimensions

Dimensions (Transmitter)	5.9" × 2" × 1" (149 × 50 × 24 mm)
Dimensions (Receiver)	2.5" × 1.5" × 1.2" (63 × 38 × 31 mm)