What to do if my Vello Camera Accessories FreeWave Plus is not working?
If you're experiencing issues with your Vello FreeWave Plus, begin by ensuring the shutter release cable is in good condition and properly connected. Also, verify that the Receiver is powered on. If problems persist, try removing the batteries from both the Transmitter and Receiver. Then, alter the channel by rearranging the DIP switches to a different combination.
General| Type | Wireless Remote Control |
|---|---|
| Channels | 16 |
| Frequency | 2.4 GHz |
| Battery Type | AAA |
| Wireless Range | 100m (328ft) |
| Power Source | 2 x AAA batteries |
| Triggering Modes | Single shot, Bulb |
Press halfway to focus; press fully to trigger shutter.
Four-second delay function gives you extra time to get in position.
Control the length of the exposure remotely.
Trigger camera wirelessly or wired. Wired triggering works if battery is dead.
Set radio frequency for Transmitter/Receiver pairs for simultaneous use.
Insert 2 AA batteries into both the Transmitter and Receiver.
Avoid disassembly, flammable gas, water, and keep away from children.
Handle batteries with care, align polarity, remove when not in use, and dispose properly.
Press and hold Power button for 2 seconds; LED flashes red.
To Next Page
