Vello WIRELESS SHUTTRBOSS 4.0 User Manual

11
SETTING THE SMART CODE
The Smart Code automatically
chooses the best frequency
for communication between
the transmitter and the
receiver. The frequency of the
transmitter and receiver is
preset so you can operate the
devices instantly. To reset the
Smart Code or add additional
receivers to the transmitter,
follow these instructions.
1. Turn on the transmitter and
receiver.
2. Use a pin to press the
receiver’s code reset button.
The receiver’s confirmation
LED will flash red and green
for up to 25 seconds.
3. Press the transmitter’s
shutter release button.
When the code is set, the
receiver’s confirmation LED
will stop flashing red and
green, and return to flashing
only green.
Note: A transmitter can control
multiple receivers simultaneously,
while a receiver can receive a signal
from only one transmitter.

Vello WIRELESS SHUTTRBOSS 4.0 Specifications

General

Self-Timer Delay	0 sec. to 99 hr. 59 min. 59.9 sec.
Exposure Time	1 sec. to 99 hr. 59 min. 59.9 sec.
Interval Time	1 sec. to 99 hr. 59 min. 59.9 sec.
Number of Shots	1 to 199, infniite
Wireless Range	196 ft. (60 m)
Power Source	Transmitter: 2 × AAA batteries (not included) Receiver: 2 × AAA batteries (not included)
Standby Time	48 hr.
Operating Temperature	14°F to 113°F (−10°C to 45°C)
Storage Temperature	14°F to 140°F (−10°C to 60°C)
Dimensions (H × W × D)	Transmitter: 5.1 × 1.8 × 0.8 in. (130 × 46 × 21 mm) Receiver: 3.3 × 1.5 × 1.2 in. (85 × 37 × 31 mm)

Weight and Dimensions

Weight	Transmitter: 2 oz. (56.5 g) without batteries Receiver: 1.4 oz. (40 g) without batteries