Function as interface
Resetting
Press the RESET button on the back of the interface for 10 seconds with
a pointed object until the red light-emitting diode is on. After this, the
light-emitting diode will turn yellow followed by a red flash.
When the light-emitting diode flashes yellow, the interface has been
reset. This may take up to 1 minute.
When resetting, all settings will be deleted and the interface reset to
factory settings.
Function as interface
Function of outputs
OUTPUT A connects to INPUT 1 and 2.
OUTPUT B connects to INPUT 3 and 4 etc.
The output function is used together with an intelligent building instal-
lation (IBI) to get feedback from KLF 200. The output function gives the
user feedback as to whether an action has been executed, eg if the win-
dow has been closed. As feedback, the built-in output relay is activated
for 2 seconds.
Intelligent building installations
io-homecontrol
®
products can be combined with most intelligent building
installations (IBI). The IBI system must include an output module with
one or more programmable outputs. When the outputs from the IBI have
been connected to the input terminals on the interface, the relevant
io-homecontrol
®
products can be controlled via the interface. With two
outputs it is possible to control both of the functions and in an
io-homecontrol
®
product or a group of io-homecontrol
®
products.
To Next Page
Loading...