If you have a VELUX INTEGRA
®
two-way
control pad KLR 200 (labelled with the
symbol
2
), you can copy the registered
products from the control pad to the inter-
face. See how on pages 12-16.
Note: If you have both a one-way and a two-way control, you can copy
the registered products from both controls using VELUX INTEGRA
®
two-way control pad KLR 200.
io-homecontrol
®
products must be registered in the interface to be
operational. You can register and operate up to 200 products.
Function as interface
Registration of products
If you only have a VELUX INTEGRA
®
one-way remote control (labelled with the
symbol
1
), you can copy the products
operated by this control to the interface.
See how on pages 17-19.
Function as interface
Functions of inputs
A single contact can be used for run-
ning products either up or down, for
instance for a blind.
Short press (under 1 second): The
product will run to end position.
Long press: The product will run until
the key is released.
A set of two contacts can be used for
running products both up and down
with variable stops by pressing both
contacts simultaneously.
A change-over contact can also be
used for running products both up and
down but stops are not possible, for
instance for a thermostat.
To Next Page
Loading...