VENGEANCE MOTORCYCLES OWNERS MANUAL
- 65 -
Vengeance Motorcycles, Mira Loma, CA USA • 866-483-6432 • www.VengeanceMotorcycles.com
© 2003 Vengeance Performance Products, LLC All Rights Reserved • VOM 1st Edition Rev 2.3 06/03
TORQUE SPECIFICATIONS
AXLE NUTS.(FRONT)..............................................................................................................................50-55 ft. Ibs.
AXLE NUTS (REAR) ................................................................................................................................60-65 ft. Ibs.
BRAKE CALIPER BOLTS (FRONT AND REAR).......................................................................................5-18 ft. Ibs.
CLUTCH CABLE LOCKNUT ...................................................................................................................... *see below
DERBY COVER SCREWS...........................................................................................................................5-7 ft. Ibs.
INSPECTION COVER SCREWS.................................................................................................................5-7 ft. Ibs.
EXHAUST MANIFOLD NUTS .................................................................................................................60-80 in. Ibs.
MIRROR MOUNTING BOLTS..................................................................................................................15-18 ft. Ibs.
OIL FILTER BRACKET SCREWS.................................................................................................................20 ft. Ibs.
PRIMARY COVER SCREWS...................................................................................................................10-12 ft. Ibs.
SHOCK ABSORBER MOUNTING NUTS .....................................................................................................75 ft. Ibs.
SPARK PLUGS .............................................................................................................................................20 ft. Ibs.
TRANSMISSION DRAIN PLUG ................................................................................................................. *see below
HANDLE BAR RISER CLAMP .................................................................................................... (5/16") 18-20 ft. Ibs.
HANDLE BAR BOLTS......................................................................................................................... (1/2") 45 ft. Ibs.
*
TIGHTEN “SNUG” ONLY – NO SPECIFIC TORQUE VALUE
VENGEANCE MOTORCYCLES ARE BUILT AND ASSEMBLED TO EXACT TORQUE SPECIFICATIONS. ANY
HARDWARE THAT HAS WORKED ITS WAY LOOSE SHOULD BE RE-TORQUED TO FACTORY
SPECIFICATIONS AS GIVEN IN THIS MANUAL. OVERTORQUEING CAN RESULT IN CRACKED GASKETS,
STRIPPED FASTENERS OR OTHER DAMAGE. AN APPROPRIATE TYPE OF "LOCTITE"™ OR OTHER FORM OF
THREAD SEALER SHOULD BE USED, WHERE APPLICABLE.
To Next Page
Loading...
