Venmar K8 HRV - User Manual

Questions and Answers

D
David DominguezAug 10, 2025
Why is there condensation on my windows with Venmar K8 HRV?
- K
  kimberlyskinnerAug 10, 2025
  If you notice condensation on your windows while using Venmar Industrial Equipment, it indicates the air is too humid. Here's what you can do: * Operate the unit on maximum speed ventilation until the situation is corrected. * Leave curtains half-open to allow air circulation. * Store all firewood in a closed room with a dehumidifier or in a well ventilated room, or store the wood outdoors. * Do not adjust the thermostat of your heating system below 18°C (64°F).
K
Kyle ReyesAug 15, 2025
What to do if the air is too cold at the air supply grille of my Venmar K8 HRV Industrial Equipment?
- S
  Susan Porter DDSAug 15, 2025
  If the air feels too cold at the air supply grille of your Venmar Industrial Equipment, try these solutions: * Make sure that the exterior hood is not blocked. * Operate the unit in low speed ventilation, in intermittent or in recirculation mode (if available). * Install a duct heater.
N
Nathaniel HolderAug 22, 2025
What to do if the LED of the integrated control is blinking AMBER on my Venmar Industrial Equipment?
- G
  Gabrielle BurkeAug 22, 2025
  If the LED of the integrated control on your Venmar Industrial Equipment is blinking amber, it indicates a problem with the motorized damper. The unit is OFF. For a 2½-hour period, the unit will try to reset the damper every 30 minutes. After 2½ hours, if the problem is not solved, the unit stops trying to reset damper. Contact your installer.
P
Peter TapiaAug 27, 2025
How to deal with indoor air that is too dry when using Venmar Industrial Equipment?
- E
  Elizabeth LittleAug 27, 2025
  If the indoor air becomes too dry while using your Venmar Industrial Equipment, you can temporarily use a humidifier, or operate the unit in recirculation mode (if available).
M
Maria WheelerSep 3, 2025
What does it mean if the LED of the integrated control is blinking GREEN on my Venmar K8 HRV Industrial Equipment?
- T
  Toni YoungSep 3, 2025
  If the LED of the integrated control on your Venmar Industrial Equipment is blinking green, it indicates a problem with the thermistor. The unit is still working, but will defrost frequently. Contact your installer.