EasyManua.ls Logo

Venmar K7 ERV - User Manual

Venmar K7 ERV
40 pages
Save Page as PDF
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
Loading...
21777J
USER AND INSTALLER MANUAL
INSTALLER: READ THESE INSTRUCTIONS
SAVE THEM FOR USER
RESIDENTIAL USE ONLY
VB0200
VB0201
SIDE PORTS TOP PORTS
K7 ERV (44162)
K8 HRV (44152)
K10 HRV (44502) K10 HRV (44500)
40E (44262)
40H+ (44252)
50H (44602) 50H (44600)
Venmar Ventilation ULC, 550 Lemire Blvd., Drummondville, Québec, Canada J2C 7W9 venmar.ca 800-567-3855

Table of Contents

Questions and Answers

  • M
    Melissa BarrAug 11, 2025
    Why is there condensation on my windows with Venmar Industrial Equipment?
    • S
      Scott GreenAug 12, 2025
      If you notice condensation on your windows while using Venmar Industrial Equipment, it indicates the air is too humid. Here's what you can do: * Operate the unit on maximum speed ventilation until the situation is corrected. * Leave curtains half-open to allow air circulation. * Store all firewood in a closed room with a dehumidifier or in a well ventilated room, or store the wood outdoors. * Do not adjust the thermostat of your heating system below 18°C (64°F).
  • L
    laura83Aug 17, 2025
    What to do if the air is too cold at the air supply grille of my Venmar K7 ERV?
    • J
      Jessica GrimesAug 17, 2025
      If the air feels too cold at the air supply grille of your Venmar Industrial Equipment, try these solutions: * Make sure that the exterior hood is not blocked. * Operate the unit in low speed ventilation, in intermittent or in recirculation mode (if available). * Install a duct heater.
  • C
    Crystal LeeAug 23, 2025
    What to do if the LED of the integrated control is blinking AMBER on my Venmar Industrial Equipment?
    • P
      Patrick McbrideAug 25, 2025
      If the LED of the integrated control on your Venmar Industrial Equipment is blinking amber, it indicates a problem with the motorized damper. The unit is OFF. For a 2½-hour period, the unit will try to reset the damper every 30 minutes. After 2½ hours, if the problem is not solved, the unit stops trying to reset damper. Contact your installer.
  • A
    Alicia RamosAug 29, 2025
    How to deal with indoor air that is too dry when using Venmar K7 ERV?
    • S
      Susan WhiteAug 29, 2025
      If the indoor air becomes too dry while using your Venmar Industrial Equipment, you can temporarily use a humidifier, or operate the unit in recirculation mode (if available).
  • J
    Jacob HartSep 5, 2025
    What does it mean if the LED of the integrated control is blinking GREEN on my Venmar K7 ERV Industrial Equipment?
    • J
      Jessica CastilloSep 5, 2025
      If the LED of the integrated control on your Venmar Industrial Equipment is blinking green, it indicates a problem with the thermistor. The unit is still working, but will defrost frequently. Contact your installer.

Venmar K7 ERV Specifications

General IconGeneral
TypeEnergy Recovery Ventilator (ERV)
Airflow CapacityUp to 200 CFM
Supply Voltage120 V
Maximum Power Consumption150 W
Core MaterialPolypropylene
Sensible Recovery Efficiency75% at 0°C (32°F)
Power Supply120 V

Related product manuals