Vent-Axia Solo SELV 12 DP - User Manual

Solo
®
SELV 12
Supply voltage to transformer/controller 220-240V/1/50Hz (Class II - )
Output to fan 12V SELV/1/50Hz (Class III -
)
Tension d'alimentation vers transformateur/contrôleur 220-240 V/1/50 Hz.
Sortie vers ventilateur 12V SELV/1/50Hz.
Versorgungsspannung für Steuertransformator: 220-240 V~, 50Hz (Klasse II -
)
Ausgangsspannung für Ventilator: 12 V/50 Hz-Einphasen-Schutz-Kleinwechselspannung (Klasse III -
)
Voedingsspanning naar transformator/regelaar 220-240 V/1/50 Hz (Klasse II -
)
Uitgangsspanning naar ventilator 12 V SELV/1/50 Hz (Klasse III -
)
Fitting and wiring instructions
Instructions de montage et de cablage
Einbau- und Anschlussanleitung
Bevestigings- en bedradingsinstructies
Fig./Abb./Afb. 1.
1. Transformer/Controller
Transformateur/contrôleur
Steuertransformator
Transformator/regelaar
2. Fan housing
Châssis de ventilateur
Lüftergehäuse
Ventilatorbehuizing
3. Grille and Filter Assembly
Ensemble grille et filtre
Gitter und Filter
Rooster- en filterconstructie
4. Fan Assembly
Unité de ventilation
Ventilatorsatz
Ventilatorconstructie
5. Accessory pack
Sachet d’accessoires
Zubehör
Toebehorenpakket
6. Frame trim
Cadre de montage
Rahmen
Framelijst
7. Ambient Response SELV 12 Humidity Controller (SELV 12H models only)
Contrôleur Ambiant Résponse d’humidité SELV 12 (modèles SELV 12H uniquement)
Umgebend Antwort SELV 12 Feuchtigkeitswächter (nur bei Modell SELV 12H)
Omgevings Responsie SELV 12 V-vochtigheidsregelaar (alleen SELV 12H-modellen)
1
7
3
4
2
5
6

Summary

Safety Instructions

Siting the Transformer;Controller

Siting the Fan

Transformer;Controller Fitting

Fan Fitting Instructions

Surface Mounting Procedure

Steps for surface mounting, including marking, cutting holes, and fixing.

Recessed Mounting Preparation

Initial steps for recessed mounting, marking and initial hole cutting.

Recessed Mounting Installation

Wiring the Transformer;Controller and Fan

Wiring Safety and Isolation

Emphasizes switching off mains supply before wiring.

Wiring Standards and Supply Requirements

Adherence to regulations and supply specifications.

SELV Wiring Separation

How to route and insulate SELV wiring from mains cables.

Electrical Connection Steps

Connecting wires to terminals as per diagrams.

System 25 Duct Installation

Airbrick Adaptor and Duct Fixing

Mortaring adaptor, fixing ducts with straps and screws.

Duct Connector and Sealant Usage

Using integral seals on connectors, no extra sealant needed.

Plenum Connection and Cable Routing

Plasterboard Cutting and Housing Fitment

Frame and Housing Assembly

Vent-Axia Solo SELV 12 DP Specifications