Need help?Do you have a question about the Vent-Axia Solo Series and is the answer not in the manual?
General guidelines for fan placement, water spray, heat sources, grease, fuel appliances, and ducted applications.
Steps to prepare the fan unit and components before installation, including removing parts and protecting them.
Instructions for mounting the fan directly onto a surface, including hole marking and cutting.
Instructions for recessing the fan unit into a wall or ceiling for a flush finish.
References to separate instructions for window or System 25 Plenum mounting methods.
Ensuring mains supply is off, double insulation, compliance with regulations, and isolator switch requirements.
How to adjust the electronic overrun timer on the Solo T model for fan operation after switch-off.
Details on single-speed (P) and dual-speed (DP) fan operation via pullcord or remote switch.
Information on timer-controlled (T) and PIR-controlled (TM2) fan operation with overrun timers.
Features of the HTP model with humidity sensor, overrun timer, and pullcord override functions.
Steps for safely removing, cleaning, and refitting the fan filter to maintain performance and appearance.
Diagram illustrating wiring for models using an integral pull-cord switch.
Diagram showing connections for models operated by a remote switch, including isolator details.
Provides UK and Republic of Ireland sales and technical support contact details.
Information on the three-year guarantee, terms, and how to claim for faulty products.
General| Installation | Wall or Ceiling |
|---|---|
| Speed | Single Speed |
| Voltage | 230V |
| Frequency | 50Hz |
| IP Rating | IP44 |
| Control Options | Timer |
| Type | Axial |
| Weight | 0.65 kg |
To Next Page