4GBVenta LP60
1 Display
2 On/o switch
3 Fragrance/lter compartment
4 Fragrance holder
5 Pre-lter
6 Premium VENTAcel H13 Filter
7 Fragrance/lter compartment
8 Fragrance holder
9 Pre-lter
10 Premium VENTAcel H13 Filter
11 Cable compartment
12 Remote control
OVERVIEW
01 06
PUTTING INTO OPERATION
01 Unpack the appliance and set it up. Open the fragrance/lter compartment
3+7, remove the pre-lter 5+9, the VENTAcel lter 6+10 and unpack them.
02 Re-insert the VENTAcel lter 6+10 and pre-lter 5+9.
03 Close the fragrance/lter compartment 3+7.
04 Inserting the fragrance: Open the fragrance/lter compartment 3 or 7.
Twist open the fragrance cap and insert it into the fragrance holder 4/8.
Insert up to three fragrances into the fragrance holder 4+8. Close the
fragrance/lter compartment 3/7.
05 The display 1 can be adjusted to three positions.
06 The power cable can be adjusted to the desired length by winding it up in
the cable compartment 11
Attention! Make sure that the appliance is switched o and the
power plug is disconnected.
Attention! The coupling of the mains cable must be plugged rmly into the
device!
Please remove the protective foil for
battery and remote control.
Connect the power plug and switch on the
appliance at the on/o switch 2 or with the
remote control 12.
Set fan stage
ON/OFF
To Next Page
Loading...
