EN 25
Display Function
6 AUTO Switch Automatic mode on or off by tapping the AUTO
button.
ON: In the display, AUTO flashes continuously and the ap-
pliance automatically regulates the power level according
to the humidity in the room.
i
When switching on AUTO, the desired humidity
humidity in the room is shown in the HUMIDITY display 1.
When the preset humidity is exceeded by more than
power level appears in the speed reading 2. No humidifi-
cation occurs.
OFF: AUTO in the display is continuously illuminated and
the appliance operates with the power level set at 1 – 3.
Hold AUTO button for 3 seconds. The HUMIDITY 1
display flashes continuously. Set the desired humidity (in
3. Hold AUTO
button for 3 seconds again until the flashing in display
HUMIDITY 1 stops and the humidity measured in the
room is shown again. Please make sure that automatic
mode is switched on: AUTO flashes continuously in the
display!
To Next Page
Loading...
