50
stations also have dump stations.
Black Tank Flush System - Optional
The flush system is designed and built to rinse the waste holding tank,
AFTER tank has been drained and dumped completely of water and
solids.
1. Attach a fresh water source to connection marked “Sewer Tank
Flusher”. Be sure termination valves are open on tanks.
2. Open valve to release water into tank for rinsing and cleaning of
your waste water holding tank.
3. Rinse for several minutes to remove any foreign matter from
tank and probes.
Remember the moisture content may give you a false reading on your
monitor panel indicating it is not empty. Allow time to dry out tank or
recharge for next usage.
Maintenance for Holding Tank
The following maintenance is recommended by the holding tank supplier
to keep your tanks clean and keep probes free of debris and build-up.
GRAY—Waste water Tank— Fill tank with 8-10 gallons of warm water.
Add a degreaser such as a citrus cleaner or Dawn dish soap. Leave the
solution in tank while traveling. Drain and rinse tank.
BLACK—Sewer Tank— Fill tank with 8-10 gallons of water. Add one
bottle of drain cleaner, such as Drano or Liquid Plumber. Leave the
solution in tank while traveling. Drain and rinse.
Heated Fresh Water Tank
Holes are placed from the fresh water tank compartment, into the floor
heat duct. This allows warm air to flow into the tank area. NOTE: The
waste holding tanks may not be heated.
Winterizing Your Recreational Vehicle
Preparing your coach for cold weather is critical in most states and
Canada. Failure to prepare your coach for weather will cause the water
systems to freeze, resulting in broken components. Damages related to
freezing are NOT covered under the terms of your limited warranty.
Two methods of winterizing your coach after draining and flushing
drainage system are listed here.
DO NOT use the tank flush valve unless the termination valve
is in open position.
Can result in an unsanitary condition leading to illness or
To Next Page
Loading...
