What to do if the scan doesn't initiate on my Verathon Scanner?
If the scan on your Verathon Scanner isn't initiating, try the following: - Ensure the probe is fully connected to the console. - Visually inspect the probe PCBA for damage; if damaged or faulty, replace it. - Replace the probe cable. - Optionally, repair or replace the DCM bottom cover assembly.
How to fix a 'Calibration required' message on a Verathon Scanner?
If you're seeing a 'Calibration required' message on your Verathon Scanner, perform a probe calibration.
What to do if my Verathon Scanner does not turn on?
If your Verathon Scanner isn't turning on, there are several things you can check: - Ensure the battery is functional and charged. - Clean or replace the battery contacts. - Make sure the power connector is connected to the DSP PCBA. - Check the power connector wire harness for any shorted or open wires; if found, replace the base housing top cover assembly. - As a last resort, replace the DSP PCBA.
What to do if my Verathon Scanner gives inaccurate scan results?
If your Verathon Scanner is providing inaccurate scan results, such as zero bladder volume or irregular bladder shape, consider the following troubleshooting steps: - Troubleshoot by using ultrasound images. - Visually inspect the probe PCBA for damage; if damaged or faulty, replace it. - Replace the probe cable. - Optionally, repair or replace the DCM bottom cover assembly.
General| Brand | Verathon |
|---|---|
| Model | BladderScan BVI 9400 |
| Category | Medical Equipment |
| Language | English |
To Next Page
