What to do if my Verderflex Water Pump has low flow/pressure?
If your Verderflex Water Pump is experiencing low flow or pressure, start by checking the pipe-work and valves for any blockages. Ensure the suction pipe-work is as short and large in diameter as possible and correct the piping layout. Also, make sure that the suction or discharge valve is open and that suction/discharge lines are properly secured.
How to reduce abnormally high temperature in Verderflex Dura 15 Water Pump?
If your Verderflex Water Pump has an abnormally high temperature, it could be due to several reasons. First, ensure you are using the correct lubricant by consulting the manufacturer. Next, check the lubricant level and add more if it's low. Also, the product ambient temperature might be too high, so consult the manufacturer regarding the maximum temperature. Finally, check for and remove any excess shims if the pump is over shimmed.
What to do if hose is pulled in to pump housing of Verderflex Water Pump?
If the hose of your Verderflex Water Pump is being pulled into the pump housing, the inlet pressure might be too high, so reduce it. Also, check the hose for blockages or incorrect fitting and remove any obstructions. If there are large particles in the product, mount a sieve or filter in the suction line, ensuring it doesn't limit suction below accepted levels.
General| Brand | Verderflex |
|---|---|
| Model | Dura 15 |
| Category | Water Pump |
| Language | English |
Critical safety warnings for operating the pump, including electrical hazards and safe practices.
Guidelines for normal pump operation, including speed limits and pressure considerations.
Factors to consider when selecting the appropriate pump size and motor.
Step-by-step instructions for installing the pump case components and bearings.
Procedures for correctly installing the drive shaft and securing it.
Guide on securely fitting the rotor to the drive shaft using specific screws.
Instructions for fitting the front cover, including O-ring placement and screw tightening.
Steps for mounting the Geared Motor Unit (GMU) onto the drive shaft.
Instructions for connecting the GMU electrical connections safely.
Guidance on preparing and installing the pump hose, including lubrication.
Critical safety precautions for maintenance and servicing, covering electrical, pressure, and general hazards.
List of spare parts for the Dura 10 peristaltic pump, including part numbers and quantities.
List of spare parts for the Dura 15 peristaltic pump, including part numbers and quantities.
To Next Page
